MASS TRANSFER WITH CHEMICAL REACTION

In this reactor contents are well stirred with the catalyst and uniform throughout. Thus exit stream from this reactor has the same composition as the fluid within the reactor. We can refer also mixed type reactor

RANGE OF EXPERIMENTS TO BE CARRIED OUT :

  1. To study mass transfer with chemical
  2. To calculate the rate constant k of given reaction

EXPERIMENTAL SETUP

Reactor                       :           Material Stainless steel (SS) ,

Flow Measurement     :           1 No. Pre calibrated Rota meter

Feed Tank                   :           2 No. of stainless steel feed tank

Feed Circulation          :           By Compressed Air

Pressure Regulator     :           0 – 2 kgf / cm2

Pressure Gauge          :           Bourdon type0 – 2 kgf / cm2

Water Bath                  :           Material SS , Double Wall ,

\ Insulated with glass Wool

Heater                         :           Nichrome wire heater

Stirrer                          :           1 No.SS impeller and shaft coupled to

FHP Motor

Digital Temp Indicator :           0 – 200 0 C , Indicator cum Controller

Temp Sensor              :           CR/AL Type

Piping                          :           SS, PVC

Setup Mounting          :            On sturdy MS stand with powder coated.

SPACE REQUIRED              :           1.5 m. ( L) x 1.0 m (W) X 1.5 m (H).

SERVICE REQUIRED:          Air Supply : @ 6 CFM, at 4 Kg /cm2

Power Supply : 230V, 50Hz, A. C.

CHEMICALS REQUIRED:    NaOH, Ethanol, Phenolphthalein indicator,

Acetic acid, Distilled water.

WEIGHT                                 : @ 55 Kg

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *